Physical & Environmental Security

CISSP CISSP · Security Architecture and Engineering

By Abu Anns · Last updated 20 November 2026Exam version: April 2024 outline (current until 15 April 2027)

Physical security is security

It is easy to treat physical security as a lesser topic — a few locks and cameras — but the CISSP treats it as a full part of Domain 3, and for good reason: an attacker with physical access to a server can bypass almost every logical control. Physical security follows the same defence-in-depth logic as network security: layered controls, from the perimeter of the site inward to the server rack, so that no single failure gives an attacker access to critical assets. The layers are typically described as the perimeter (fences, gates, lighting, natural barriers), the building (doors, locks, mantraps, reception), the interior (access-controlled zones, locked rooms, cabinets), and the object (locked racks, cable locks, tamper-evident seals). The exam expects you to think in layers and to recognise that each layer buys time and creates evidence, even if it cannot stop a determined attacker indefinitely.

Site selection and facility design

Choosing where to put a facility is a security decision. The exam lists the factors: visibility (a data centre should be inconspicuous, without signage advertising its contents), proximity to hazards (flood plains, earthquake zones, flight paths, hazardous material facilities, and high-crime areas should be avoided), accessibility for emergency services, availability of reliable power and multiple network providers, and the local climate (which affects cooling costs and risks). The facility itself should be designed with security zones: public areas (lobby, reception) separated from restricted areas (offices) and highly restricted areas (data centres, network rooms), with access controls tightening at each boundary. Server rooms should have no windows, should be located away from exterior walls where possible, and should not be on the ground floor (flood risk) or the top floor (roof leak and access risk) — the middle floors are preferred. Doors, walls and ceilings must extend to the true ceiling (a dropped ceiling with a gap above the wall is an easy bypass), and raised floors and cable conduits are potential access paths that must be secured.

Physical access controls

Physical access controls mirror logical ones: something you have (a badge, a key, a smart card), something you know (a PIN or combination), and something you are (a fingerprint, iris scan, or other biometric). High-security areas combine factors — a badge plus a PIN, or a badge plus a biometric. Mantraps (airlock-style double doors where only one door opens at a time) prevent tailgating and piggybacking, where an unauthorised person follows an authorised person through a door. Turnstiles serve a similar purpose at scale. Security guards are the most flexible control — they can exercise judgement, respond to incidents and deter intruders — but they are also the most expensive and the most variable in quality. CCTV provides deterrence and evidence; the exam notes that cameras should cover entry points, sensitive areas and the perimeter, and that recordings must be protected and retained according to policy. Visitor management requires logging, escorts for visitors in restricted areas, and badges that identify visitors visibly. The exam's favourite physical access trap is tailgating: the correct answer to a tailgating scenario is almost always a mantrap, turnstile, or awareness training — not a stronger lock on the door.

Biometrics

Biometric authentication is tested in both Domain 3 (physical) and Domain 5 (logical), and the key concepts are the same. Biometric systems compare a live sample against a stored template and produce a similarity score; a threshold determines acceptance. Two error rates define a system's accuracy: the False Acceptance Rate (FAR) — the rate at which unauthorised users are wrongly accepted (a security failure) — and the False Rejection Rate (FRR) — the rate at which authorised users are wrongly rejected (a usability failure). These two rates trade off against each other: raising the threshold lowers the FAR but raises the FRR. The Crossover Error Rate (CER), also called the Equal Error Rate, is the point where FAR equals FRR, and it is the standard measure for comparing biometric systems — a lower CER means a more accurate system. Biometric factors include fingerprints, iris patterns, retina scans, facial recognition, voice, and behavioural biometrics such as keystroke dynamics. Iris recognition is generally the most accurate; fingerprints are the most common. The exam also notes the key weakness of biometrics: unlike a password, a biometric cannot be changed if compromised, and biometric data must be protected as sensitive personal data.

Fire protection

Fire is one of the most destructive physical threats, and the exam covers detection and suppression in detail. Detection comes first: smoke detectors (ionisation detectors respond fastest to flaming fires; photoelectric detectors respond fastest to smouldering fires), heat detectors (triggered by a fixed temperature or a rapid rate of rise), and flame detectors (which sense infrared or ultraviolet light from flames). Suppression must match the environment. Water sprinklers are the most common suppression system, but water damages electronics — so data centres use gas-based systems instead. Clean agent systems (such as FM-200 or Novec 1230) extinguish fire by interrupting the chemical reaction and leave no residue; they replaced Halon, which was effective but depletes the ozone layer and is banned for new installations. CO2 systems displace oxygen but are lethal to people in the room, so they are used only in unoccupied spaces. Sprinkler systems have variants the exam tests: wet pipe (water always in the pipes — simplest and most reliable, but a leak or accidental activation floods the area), dry pipe (pipes filled with pressurised air; water enters only when a sprinkler head opens — used where freezing is a risk), pre-action (requires two triggers, typically a smoke detector and a sprinkler head, before water flows — the best choice for data centres because it minimises the risk of accidental water damage), and deluge (all heads open at once, used in high-hazard areas). The exam's most reliable fire question: a data centre should use a pre-action sprinkler system, not a wet pipe system.

Suppression typeHow it worksBest for
Wet pipe sprinklersWater always in pipes; head opens on heatGeneral offices; simple and reliable
Dry pipe sprinklersAir in pipes; water enters when head opensUnheated areas where pipes could freeze
Pre-action sprinklersTwo triggers required before water flowsData centres and rooms with sensitive electronics
Clean agent gas (FM-200, Novec)Gas interrupts combustion; no residueServer rooms; safe for occupied spaces
CO2Displaces oxygenUnoccupied spaces only — lethal to people

Power and environmental controls

Power is a security concern because losing it means losing availability. The layers are: surge protectors (absorb brief voltage spikes), uninterruptible power supplies (UPS) (batteries that provide minutes of power — enough for a graceful shutdown or for a generator to start), and generators (which provide hours or days of power but need fuel, maintenance and regular testing). The exam distinguishes power problems by their characteristics: a spike is a brief high-voltage surge; a surge is a longer over-voltage; a sag (or brownout) is a brief under-voltage; a blackout is a total loss of power; and noise is interference on the power line. Environmental controls include HVAC (heating, ventilation and air conditioning — servers need stable temperature, typically 18–27°C, and humidity, typically 40–60% relative humidity; too dry causes static electricity, too humid causes condensation), water detection sensors under raised floors, and positive air pressure in clean areas to keep dust out. The exam also covers electromagnetic interference (EMI) and the concept of TEMPEST — the US government standard for limiting electromagnetic emissions that could be intercepted to reconstruct data from a system (for example, reading a monitor's display from its emissions). Shielding, such as a Faraday cage, is the countermeasure for facilities with the highest sensitivity.

Exam mindset for physical security

Physical security questions reward matching the control to the environment: pre-action sprinklers for data centres, mantraps for tailgating, clean agent gas where water would destroy equipment, UPS plus generator for power continuity. And remember the human element: guards and awareness training are controls too, and a locked door is useless if employees hold it open for strangers.

Advertisement

Exam traps to watch for

Practice questions

Test yourself on this guide. Answers are checked instantly, with a full explanation for each question.

Q1.A company is building a new data centre. Which fire suppression system is the BEST choice for the server room?

Report an error

Q2.Employees report that strangers have been entering the office by following authorised staff through the secure entrance. Which control BEST addresses this problem?

Report an error

Q3.A security team is comparing two biometric systems. System A has a Crossover Error Rate (CER) of 1% and System B has a CER of 4%. Which statement is correct?

Report an error

Q4.A data centre experiences a total loss of mains power. The UPS provides 15 minutes of battery power and the standby generator takes 60 seconds to start. What is the PRIMARY purpose of the UPS in this design?

Report an error

Q5.A government facility handles classified information and is concerned that an attacker could reconstruct data from the electromagnetic emissions of its computer monitors. Which standard and countermeasure address this threat?

Report an error

Q6.A server room’s humidity has dropped to 15% relative humidity during winter. What is the MOST significant risk this creates?

Report an error

Q7.When selecting a site for a new data centre, which factor should be given the HIGHEST priority from a security perspective?

Report an error

Q8.A company stores backup tapes in a room with a standard door lock. The tapes contain unencrypted customer data. An audit identifies this as a high-risk finding. What is the BEST remediation?

Report an error